ppfree.blogg.se

Do i need a driver for a shure microphone on a mac
Do i need a driver for a shure microphone on a mac







do i need a driver for a shure microphone on a mac
  1. Do i need a driver for a shure microphone on a mac how to#
  2. Do i need a driver for a shure microphone on a mac windows#

Do i need a driver for a shure microphone on a mac how to#

Learn how to connect the two in our tutorial “How to Connect Your Microphone to an Audio Interface” So now you have a microphone and an audio interface. Therefore, we recommend getting an audio interface with its own power supply. Quite often, the voltage is too low or the available current insufficient to power a condenser microphone properly, which could result in increased noise and/or reduced audio quality. Therefore, lowest power consumption is of highest priority – often at the cost of audio quality.Īlso, bus powered audio interfaces rarely deliver true P48 phantom power. This is called “bus power.”īus powering seems like a convenient solution, but it does have some drawbacks: Bus power, especially on USB 2.0 interfaces, does not deliver very much energy. There are usually no problems with USB 3.0 ports on Macintosh computers.Ī note on bus powered audio interfaces: Some audio interfaces come without a wall plug or external PSU, they draw all the power they need from the computer they’re connected to.

Do i need a driver for a shure microphone on a mac windows#

Theoretically, there should be backwards compatibility, but in practice that’s not always the case, at least on the Windows platform. Please be aware that USB 2.0 audio interfaces do not always work well on USB 3.0 computer ports (which usually have a blue plastic insert). These are by far the most common, and also the most cost effective models. If you’re unsure what’s best for you, get a USB 2.0 interface. USB 3.0 is much faster than USB 2.0, but there may be compatibility problems, since it’s a fairly new technology (for audio interfaces USB 3.0 hard drives have been around for some years) USB 3.0 interfaces are only beginning to emerge. Just a cable is 40-50 dollars/euros, and Thunderbolt audio interfaces usually come without a cable.įireWire is outdated and not recommended for new purchases. Also, Thunderbolt is a fairly expensive technology. Thunderbolt is very fast protocol, but is common only on the Macintosh platform.

do i need a driver for a shure microphone on a mac

USB 2.0 is not the fastest protocol, but its bandwidth is sufficient for small to medium sized interfaces. USB 2.0 is the most common interface to add peripherals to both Windows and Macintosh computers. So, before you buy, visit the manufacturer’s website to see if there is a driver version for your operating system. Most audio interfaces require a dedicated driver to be installed on your system. Make sure your audio interface comes with a digital port (such as USB) that is compatible with your computer.If your audio interface comes without monitor outputs and a volume knob, you have to get an external monitor controller at additional cost. That’s what the volume knob on your audio interface is for. You can only control the loudness by attenuating the incoming signal. However, they usually come without a volume control. Studio monitors (including inexpensive ones for home studio use) are powered speakers, i.e. Monitor outs for your speakers and a volume knob on the front panel.add additional instruments or vocals to the tracks you’ve already recorded, you must use headphones and mute your speakers to avoid crosstalk. Instrument inputs are useful for guitars and basses, if you want to record the “bare” signal (which sounds somewhat sterile) or use amp modeling software. You need line inputs for synthesizers, drum machines and other equipment with a medium to high output level. Obviously, you don’t need those to make microphone recordings, but they’re very useful to have. Additional inputs for line signals and instrument signals.Also, phantom power does not affect dynamic microphones that do not require external power. The beauty of this solution (a Neumann invention) is that it does not require any additional leads but uses normal XLR cables. This is a way of powering condenser microphones from the microphone input. Phantom power (often labeled “P48” or “48V”).At least one XLR microphone input for stereo recordings you obviously need two.Good ones, which offer superior sound and better quality overall, start at about 400-500 dollars/euros. Stay away from the cheapest models 200 dollars/euros is about the minimum for a decent audio interface. You won’t find them in most computer stores, but you can buy them online or locally from any retailer of musical instruments. These devices are called audio interfaces and are offered by numerous manufacturers. Luckily, there are devices that cover all of those requirements, and then some.









Do i need a driver for a shure microphone on a mac